Operation Instructions - Whirlpool XT-20EG/S Instructions For Use Manual

Use to set power level. To check power level
during time cooking, touch POWER pad.
PRE-SET
Use to set the oven to start-up at a later time.
The pre-set indicator will flicker when the oven
is in the PRE-SET state. The clock must be set
before the pre-set function can be programmed.
CANCEL
Touch to cancel the selected power level, cook
or defrost times that previously programmed.
But the time of day clock cannot be cancelled.
START
Touch to start the cooking or defrosting
programs. The cooking indicator light and the
oven light will turn on and the cooling fan will
BEEP DURING OVEN SETTINGS
Each time a pad is touched, a beep will sound
to acknowledge the touch.
SETTING THE CLOCK
Suppose you want to enter the correct time of
day6: 00(A.M or P.M).
Step: 1. Touch CLOCK pad.
2. Touch CANCEL pad.
3. Touch number pad
4. Touch CLOCK pad again to confirm.
NOTE: This is a 12-hour clock. When the
oven was plugged in, "1:01" should have
appeared in the display. To reset the time of
day, repeat the steps given above. You can
check the clock time while cooking is in
progress by touching the CLOCK pad.

OPERATION INSTRUCTIONS

1
6 times.
MIN
operate.
CLOCK
Use to set the time of day or recall the time of
day. The time of day will be displayed at all
times except when the oven is operating. In the
event of a power failure or if the oven is
unplugged, the clock will have to be reset.
MEMORY
When programming the oven to cook by time,
use the MEMORY pad when setting both the
1st and the 2nd cooking stage.
The respective lights will come on to indicate
which stage the oven is operating in.
SETTING COOKING TIMES AND
POWER LEVELS
Suppose you want to cook for 5 minute at 60%.
Step: 1. Touch MICRO pad.
2. Touch number pad
3. Touch POWER pad 3 times.
4. Touch START pad.
NOTE: Step 3 is not necessary for cooking at
100% power level.
PRE-SET
Suppose you want to set the oven to start-up at
2 o'clock.
Step: 1. Touch PRE-SET pad.
2. Touch number pad
3. Set the cooking programs.
4. Touch START pad.
NOTE: Be sure the time of day clock is set at
7
1
five times.
MIN
1
twice.
MIN