Exterior Lamps Off Reminder; Headlamp High/Low-Beam; Changer - Cadillac CT4 Owner's Manual

Cadillac CT4 Owner Manual (GMNA-Localizing-MidEast-15283644) - 2022 -
CRC - 7/28/21
To enable the IntelliBeam system,
press on the turn signal lever
when it is dark outside and the
exterior lamp control is in AUTO
or .
Driving with IntelliBeam
The system only activates the high
beams when driving over 40 km/h
(25 mph).
The blue high-beam on light appears
on the instrument cluster when the
high beams are on.
There is a sensor near the top center
of the windshield that automatically
controls the system. Keep this area of
the windshield clear of debris to allow
for best system performance.
The high-beam headlamps remain on,
under the automatic control, until one
of the following situations occurs:
The system detects an approaching
vehicle's headlamps.
The system detects a preceding
vehicle's taillamps.
The outside light is bright enough
that high-beam headlamps are not
required.
The vehicle's speed drops below
20 km/h (12 mph).
The IntelliBeam system is disabled
by the button on the turn signal
lever. If this happens, press
the turn signal lever when the
exterior lamp control is in the
AUTO or position to reactivate
the IntelliBeam system. The
instrument cluster light will come
on to indicate the IntelliBeam
system is reactivated.
The high beams may not turn off
automatically if the system cannot
detect another vehicle's lamps because
of any of the following:
The other vehicle's lamps are
missing, damaged, obstructed from
view, or otherwise undetected.
The other vehicle's lamps are
covered with dirt, snow, and/or road
spray.
The other vehicle's lamps cannot be
detected due to dense exhaust,
smoke, fog, snow, road spray, mist,
or other airborne obstructions.
LIGHTING
The vehicle's windshield is dirty,
cracked, or obstructed by something
that blocks the view of the light
sensor.
The vehicle is loaded such that the
on
front end points upward, causing
the light sensor to aim high and not
detect headlamps and taillamps.
Driving on winding or hilly roads.
The automatic high-beam headlamps
may need to be disabled if any of the
above conditions exist.
Exterior Lamps Off
Reminder
A warning chime sounds if the driver
door is opened while the ignition is off
and the exterior lamps are on.

Headlamp High/Low-Beam

Changer

: Push the turn signal lever away
from you and release, to turn the high
beams on. To return to low beams,
push the lever again or pull it toward
you and release.
127