Advertisement
Quick Links
Advertisement
Related Manuals for Prorack K571
Summary of Contents for Prorack K571
- Page 1 K571 Fitting Kit GB Fitting Instruction for Accessory Revision No:...
- Page 2 Fitting Kit K571 MAX kg MAX kg W/P WHD W/P WHD 1 Series E82, 2dr Coupe 07-+ 1 Series E82, 2dr Coupe 07-+ 1 Series E82, 2dr Coupe 07-+ 1 Series E82, 2dr Coupe 07-+ 1 Series E82, 2dr Coupe 07-+...
-
Page 3: First Time Installation
Fitting Kit K571 First Time Installation Remove parts from packaging and check contents. Contact your Prorack dealer if parts are missing or damaged. These instructions show type A crossbar fitted. They also apply to type B, C and D. This kit fits type A, B, C and D. - Page 4 Fitting Kit K571 Use hex screwdriver to reverse adjusting screw 10 turns. Press adjusting screw and pull crossbar legs out. Refer to the crossbar instructions for crossbar adjustment. Ensure each end of the crossbar is adjusted equally. Attaches to factory-fitted mounting points...
- Page 5 Fitting Kit K571 Tighten adjusting screw to 5 Nm. Remove clamp block by pressing backwards. Select plastic internal block (from fitting kit) and insert into foot. Repeat for all legs.
- Page 6 Fitting Kit K571 Fitment Open or remove fixed-point covers. Select grubscrews and screw into the vehicle's fixed points. Do not over tighten. Repeat for all four positions. Refer to the underside of the pad for the part number.
- Page 7 Fitting Kit K571 It is important to put the pads in the correct position on the vehicle. Letters refer to the pad part numbers and position. Pad Part Number: A = 11-04-233 B = 11-04-234 Ensure the fixed-point covers sit vertically in the recess in the pads.
- Page 8 Fitting Kit K571 Tighten the red plastic knob. The side with the nut showing should be facing up. Ensure the red plastic knob is in the position shown when fully tightened. Repeat for all legs. Check crossbar is securely attached to the vehicle.
- Page 9 Fitting Kit K571 CAUTION: Recheck all fasteners immediately after a load is applied to the crossbars. Regularly check screws are tight.
-
Page 10: Maintenance
Fitting Kit K571 Maintenance Clean the car roof and surfaces of the product that will be in contact with the car roof. Follow the fitting instructions for fitting the product to your vehicle. Make sure all steps are carried out in order. - Page 11 Fitting Kit K571 A loaded roof rack system can alter the performance of your vehicle. Be especially aware of the effects of side winds, changing of direction, and braking performance. Avoid rapid acceleration and deceleration. Drive carefully. Note that the total height of the vehicle increases when upright loads are carried.
- Page 12 Fitting Kit K571 -47cm 27cm 825mm 815mm BMW 1 Series E82, 2dr Coupe 07-+ (AU) -18 1/2" 10 5/8" 32 1/2" 32 1/16ths" -47cm 27cm 825mm 815mm BMW 1 Series E82, 2dr Coupe 07-+ (EU) -18 1/2" 10 5/8" 32 1/2"...
Need help?
Do you have a question about the K571 and is the answer not in the manual?
Questions and answers