Installation Instructions - GE JAP02SNSS Owner's Manual And Installation Instructions

Installation
Instructions
Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: www.GEAppliances.com
BEFORE YOU BEGIN
Read these Instructions completely
and carefully.
IMPORTANT -
instructions for local inspector's use.
IMPORTANT -
governing codes and ordinances.
Note to Installer - Be sure to leave these
instructions with the Consumer.
Note to Consumer - Keep these
instructions for future reference.
Completion time - 1 to 3 hours
Proper installation is the responsability of
the installer.
Product failure due to improper installation
is not covered under the Warranty.
WARNING -
be properly grounded.
FOR YOUR SAFETY:
WARNING -
installation, switch power off at service panel
and lock the service disconnecting means to
prevent power from being switched on
accidentally. When the service disconnecting
means cannot be locked, securely fasten a
prominent warning device, such as a tag, to
the service panel.
All rough-in and spacing dimensions must be
met for safe use of your range. Electricity to
the range can be disconnected at the outlet
without moving the range if the outlet is in
the preferred location (remove lower drawer).
24" GE Electric Ranges
Save these
Observe all
This appliance must
Before beginning the
FOR YOUR SAFETY:
To reduce the risk of burns or fire when
reaching over hot surface elements, cabinet
storage space above the cooktop should be
avoided. If cabinet storage space is to be
provided above the cooktop, the risk can
be reduced by installing a range hood that
projects at least 5" beyond the front of the
cabinets. Cabinets installed above a cooktop
must be no deeper than 13" .
Be sure your appliance is properly installed
and grounded by a qualified technician.
Make sure the cabinets and wall coverings
around the range can withstand the temperatures
(up to 200°F) generated by the range.
ANTI-TIP DEVICE:
To reduce the risk of tipping the range,
the range must be secured by a properly
installed anti-tip bracket. See installation
instructions shipped with bracket for complete
details before attempting to install.
To check the bracket is installed and engaged
properly, carefully tip the range forward. The
bracket should stop the range within 4 inches.
If it does not, the bracket must be reinstalled.
If the range is pulled from the wall for any
reason, always repeat this procedure to verify
the range is properly secured by the anti-tip
bracket.
If your range has no ant-tip bracket, call
1-800-626-8774 to receive one at no cost
31
WARNING!
ANTI-TIP DEVICE
ALL RANGES CAN TIP
BURNS OR OTHER SERIUS
INJURIES CAN RESULT
INSTALL AND CHECK THE
ANTI-TIP BRACKET
FOLLOWING THE
INSTRUCTIONS SUPPLIED
WITH THE BRACKET
.