Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Tecumseh GEO-TEC
Summary of Contents for Tecumseh GEO-TEC
- Page 3 OIL AND FUEL Pour slowly. 5. Screw the filler cap in completely. To ensure good operation of the TECUMSEH motor FOR FURTHER INFORMATION REGARDING THE OIL, always use: WE REFER YOU TO THE “MAINTENANCE” CHAPTER.
- Page 4 (5) BATTERY MAINTENANCE B. Move the motor control lever or the remote con- trol of the machine to the RUN or LEPRE position (E.S. MODELS) (see the instructions of the machine manufacturer) (Figs. 6-5, 6-1). A. After purchase, charge the batteries for 24 hours, using the battery charger provided or any C.
- Page 5 Spare parts are C. MOVE THE STARTER SWITCH TO “OFF” obtainable through the Tecumseh service network. AND REMOVE THE STARTER KEY (IF THE MOTOR IS FITTED WITH THESE OPTIONS).
- Page 6 SPECIAL OPEN-AIR CONTAINER, WHERE NOT covered by warranty. THERE ARE NO OPEN FLAMES, AFTER CHECKING THAT THE MOTOR IS COLD. DO 10) The list of TECUMSEH authorised service stations NOT SMOKE DURING THIS OPERATION. is available from the national distributor.
Need help?
Do you have a question about the GEO-TEC and is the answer not in the manual?
Questions and answers
Какой диаметр вала для шкива?
The shaft diameter for the Tecumseh GEO-TEC is 22.00 mm.
This answer is automatically generated
Здравствуйте! Двигатель заглох и перестал заводиться. На свече нет искры . На новой свече тоже нет искры. Как устранить неисправность ?
To fix a Tecumseh GEO-TEC engine that has no spark on the spark plug:
1. Disconnect the high tension spark plug lead.
2. Remove the spark plug and inspect it:
- Replace it if the electrodes are pitted, burned, or the porcelain is cracked.
- Use only the specified spark plug type (RJ19LM or equivalent) with a thread length of 8 mm (19 mm for OHV). Using a longer thread plug may damage the engine.
3. If reusing the spark plug:
- Clean it and check the electrode gap. It should be 0.6 mm.
4. Reinstall the spark plug tightly.
5. Reconnect the high tension spark plug lead.
If there is still no spark after this, the problem may be with the ignition system, such as a faulty ignition coil, damaged wire, or improper grounding.
This answer is automatically generated