In Case Of Malfunctions - Elipson P1 User Manual

EN

IN CASE OF MALFUNCTIONS

POSSIBLE CAUSES AND TEST PROCEDURES :
• Very low signal or no signal at all on one or both
channels.
1. Check that the gain/volume is not at minimum
on the preamplifier or that the «mute» function is not
activated.
2. Check that the power amplifier is well connected
and on active mode
3 Check that the selected source is correct
according to your final choice
4. The interconnect audio cable may be defective
or of poor quality. Replace it with a known and
trusted brand.
52
• Humming noise in the loudspeakers
1. The humming noise may be caused by a potential
problem or a different ground between the
connected devices.
2. Check the condition of the cables (loudspeakers
/ preamplifier), the source used, and the grounding
in the case of the phono board. Be sure to insert,
if needed, the fork of the ground wire inside the
knurled screw.
3. Reverse the outlet of the devices if you own a F-
Shunko strip or outlet.