Table of Contents
Advertisement
The remote power supply voltage is fed onto LDS card interfaces via a cable terminating in
the connector J4 (2-pin MAT & LOCK). This connector is used to connect the PLDS card.
The polarity of connector J4 is as follows:
♦
plus (+)
♦
minus (-)
CAUTION: The use of 40 V is restricted to a number of equipment cards.
PAGE
76/171
This confidential document is the property of MATRA NORTEL COMMUNICATIONS and may not be copied or circulated without permission.
Ce document confidentiel est la propriété de MATRA NORTEL COMMUNICATIONS et ne doit pas être reproduit ou communiqué sans autorisation.
J4-2
J4-1
Figure 19: PLDS card
For example, LAB, LAN, and LAI must be supplied by 48 V.
LCAH-30521-001-05=01/EN
Advertisement
Table of Contents
Need help?
Do you have a question about the MC 6500 and is the answer not in the manual?