Matra Nortel MC 6500 Manual page 46

On the main distribution frame, configure radio base station 1 as "master".
Connect radio base station 2 as "slave" to strip J4 (pins 1 to 4).
There are two methods of connecting the two synchro wires for the "slave" radio base
station:
1. either directly to strip J6 (pins 1 and 2) on the ROCZB card
2. or to strip J5 (pins 1 and 2) on the ROCYE card; in this case connect pins 1 and 2
of strip J5 (ROCYE card) and strip J6 (ROCZB card).
Note: The second solution (see Figure 12) is not mandatory. However, it will facilitate
the installation of a third base station.
PAGE 46/171
This confidential document is the property of MATRA NORTEL COMMUNICATIONS and may not be copied or circulated without permission.
Ce document confidentiel est la propriété de MATRA NORTEL COMMUNICATIONS et ne doit pas être reproduit ou communiqué sans autorisation.
LCAH-30521-001-05=01/EN