Connecting A Radio Base Station To The Expansion Distribution Frame; Figure 9: Connecting A Radio Base Station To The Expansion Distribution Frame - Matra Nortel MC 6500 Manual

3.3.5 CONNECTING A RADIO BASE STATION TO THE EXPANSION DISTRIBUTION
FRAME
Note: No radio base station is wired to the main distribution frame.

Figure 9: Connecting a radio base station to the expansion distribution frame

Connect the two pairs (Rx/Tx) directly to strip J4 (pins 1 to 4).
Connect the EOCT card to the other side of strip J4.
Note: Although the two synchro cables are not necessary for this setup, you are
recommended to wire them in preparation for future expansion.
PAGE 44/171
This confidential document is the property of MATRA NORTEL COMMUNICATIONS and may not be copied or circulated without permission.
Ce document confidentiel est la propriété de MATRA NORTEL COMMUNICATIONS et ne doit pas être reproduit ou communiqué sans autorisation.
LCAH-30521-001-05=01/EN