Connecting A Radio Base Station To The Main And Expansion Distribution Frames; Figure 4: Connecting A Radio Base Station To The Main And Expansion Distribution Frames - Matra Nortel MC 6500 Manual

3.1.4 CONNECTING A RADIO BASE STATION TO THE MAIN AND EXPANSION
DISTRIBUTION FRAMES
Note: Connect the radio base station to the ROCZB card using an 8-pin ribbon cable.

Figure 4: Connecting a radio base station to the main and expansion distribution frames.

On the main distribution frame, configure radio base station 1 as "master".
Connect slave radio base station 2 to strip J4 (pins 1 to 4).
There are two methods of connecting the two synchro wires for the "slave" radio base
station:
1. either directly to strip J6 of the ROCZB card (pins 1 and 2)
2. or to strip J5 of the ROYCE card (pins 1 and 2); in this case, connect pins 1 and 2
of strip J5 (ROYCE card) and strip J6 (ROCZB card).
PAGE 28/171
This confidential document is the property of MATRA NORTEL COMMUNICATIONS and may not be copied or circulated without permission.
Ce document confidentiel est la propriété de MATRA NORTEL COMMUNICATIONS et ne doit pas être reproduit ou communiqué sans autorisation.
LCAH-30521-001-05=01/EN