Verification Of The Programming Parameters - Matra Nortel MC 6500 Manual

9.3.9 CHECKING THE PROGRAMMING PARAMETERS
When you have associated the radio base stations with the trunk and defined
characteristics, view their statuses to check that the operation was successful.
To display, use the MMC XBORFA. Configuring the "radio station access mode" parameter
allows you to select one of the two viewing modes proposed: TRUNK based mode and
BOARD based mode.
To enter the BOARD based viewing mode, define the following parameters:
♦
Trunk group access mode: BOARD
♦
CCU (cluster):
♦
Board type:
♦
Number:
♦
Access:
The viewing screen displays the following information:
♦
number of trunk groups on this access
♦
access status
♦
radio base station characteristics
Example of the screen display (BOARD based viewing mode)
Obj.=RadSta
------------------------- RADIO STATIONS ACCESS -----------------------
CCU=3. Board type=LDS
---------------------------- CHARACTERISTICS --------------------------
Radst=2-chan
Trunk Gp=0. Access status= IN SERVICE
TS Frame assignment=111111111111
Anten. choice=Automatic
Type of RadSt=Slave
Software variant=24
LCAH-30521-001-05=01/EN
This confidential document is the property of MATRA NORTEL COMMUNICATIONS and may not be copied or circulated without permission.
Ce document confidentiel est la propriété de MATRA NORTEL COMMUNICATIONSet ne doit pas être reproduit ou communiqué sans autorisation.
enter the number of the cluster supporting the DECT
card
LDS
enter card number
enter the access number corresponding to the radio
base station
TRUNK GROUP AND TRUNKS
11--------->0
Action=Display
RadStations Access mode=BOARD
Number=2
Freq.assignment=1111111111
Inscript. Radio Stat.=YES
Distance master RadSt=0 to 100m
Acces.=2
Bus=short
9------->0
PAGE 129/171