Putting Cards And Dect Base Stations In Service - Matra Nortel MC 6500 Manual

9.2.4.4 ASSOCIATING A TRUNK TO THE RADIO BASE STATION
Note: to declare a DECT trunk group in a cell, all base stations in the cell must be out of
service. The number of base stations in a cell must never exceed 8.
9.2.4.5 COVERAGE DISPLAY
Using Menu 1.8.2.5 or Menu 1.9.2.5 (Multi-company management), check declarations
concerning the radio coverage.
9.2.5

PUTTING CARDS AND DECT BASE STATIONS IN SERVICE

The Menu BASE STATION ALLOCATION allows you to declare 2 or 4 channel DECT radio
base stations and put them in service.
Before using this menu, follow the instructions given below.
9.2.5.1 PRELIMINARY OPERATIONS AND CHECKS
Before putting the base stations in service, you must follow the preliminary procedures
given below:
♦
delete S0 users previously declared on, the S0 accesses required for DECT
interfaces
♦
put the DECT interface cards in service
♦
check the status of the cards and radio base stations
9.2.5.2 DELETING S0 USERS
Radio base stations are declared to S0 accesses for the various S0 interface cards.
Depending on the previous registrations of users, all users declared on these accesses
should be checked and deleted, should the occasion arise.
Use Menu 1.1.6.1 (Extension directory) and Menu 1.1.5 (Add/Delete Extensions).
9.2.5.3 PUTTING DECT INTERFACE CARDS IN SERVICE
The number of the menu Card Management varies depending on the range to which the
PBX belongs:
♦
For PBX in the F0 and F1 ranges, use Menu 3.2
♦
For PBX in the F2 range, use Menu 3.2.1
PAGE 108/171
This confidential document is the property of MATRA NORTEL COMMUNICATIONS and may not be copied or circulated without permission.
Ce document confidentiel est la propriété de MATRA NORTEL COMMUNICATIONS et ne doit pas être reproduit ou communiqué sans autorisation.
TRUNK GROUP DEFINITION- BLDG A
LOCATED IN CELL BLDG A
LCAH-30521-001-05=01/EN