Advertisement
Quick Links
Installation
Instructions
Questions? Call GE Answer Center at 800.626.2000
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT –
•
instructions for local inspector's use.
IMPORTANT –
•
governing codes and ordinances.
Note to Installer –
•
instructions with the Consumer.
Note to Consumer –
•
instructions for future reference.
FOR YOUR SAFETY:
WARNING –
installation, switch power off at service panel and lock
the service disconnecting means to prevent power
from being switched on accidentally. When the service
disconnecting means cannot be locked, securely fasten
a prominent warning device, such as a tag, to the
service panel.
TOOLS YOU WILL NEED
Phillips screwdriver
Pencil
Awl or punch
READ CAREFULLY.
KEEP THESE INSTRUCTIONS
Save these
Observe all
Be sure to leave these
Keep these
Before beginning the
Drill with
7
⁄
bit or #35
64
Tape measure
.
Built-In Trim Kits
JX1827 and JX1830
or
Visit our Website at:
• Unplug the microwave oven before attempting
installation of this kit.
• Skill level – Installation of this appliance requires basic
mechanical and electrical skills.
• Completion time – 1-3 hours
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not
covered under the Warranty.
• This kit is UL listed for installation alone or over any
General Electric/Hotpoint/RCA single electric wall
oven.
PARTS INCLUDED
PART
1
www.GEAppliances.com
QUANTITY
Trim Frame
Bottom Duct
Side Duct
1" Screws
(4 required, 2 extra)
1/2" Screws
(11 required, 4 extra)
Anti-Tip Bracket
Bottom Bracket
Upper Duct
Template
1
1
1
6
15
1
1
1
1
Advertisement
Related Manuals for GE JX1827CB
Summary of Contents for GE JX1827CB
-
Page 1: Installation Instructions
Installation Instructions Questions? Call GE Answer Center at 800.626.2000 BEFORE YOU BEGIN Read these instructions completely and carefully. IMPORTANT – • instructions for local inspector’s use. IMPORTANT – • governing codes and ordinances. Note to Installer – Be sure to leave these •... -
Page 2: Cutout Dimensions
Fasten the bottom bracket to the bottom duct by using two ⁄ screws. Front Rear ⁄ Screws (2) Remove any loose items inside the microwave oven, including the turntable and turntable support. Carefully turn the microwave upside down. Install bottom duct with four ⁄ screws as shown. Screws... - Page 3 Set the microwave upright, being careful not to bend the front flange. Remove the one existing screw from the left side of the microwave oven. Peel off the backing of the double sided tape. Carefully position the side duct and upper duct assembly on the microwave cabinet, aligning with the bottom screw hole.
-
Page 4: Install Microwave Oven
INSTALL MICROWAVE OVEN INTO CABINET Slide the microwave oven part way into the cabinet opening. Bottom Duct Anti-Tip Bracket Bottom Bracket Plug in the microwave oven. Bottom bracket must be flat to the cutout floor to engage correctly with the anti-tip bracket as shown.