Start Up - Cold Jet Aero 40FP Operator's Manual

UNIT OPERATION
IN THIS SECTION

Start Up. . . . . . . . . . . . . . . . . . . . . . . . . . 13

Blast Cleaning Technique. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
Re-loading Dry Ice . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
Shut Down . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
START UP
Read all safety instructions before operation and follow them closely (p. 2-4).
Always wear proper personal protective equipment including eye protection to guard against
to cryogenic temperatures.
Before loading dry ice, purge with compressed air to be sure the system is clear of excess
moisture and debris.
To start the Aero 40FP:
1.
2. Attach the blast hose and control cable to the machine.
3. Attach the applicator to the blast hose and control cable.
4. Attach a nozzle to the applicator.
5. Attach the whip check to the air supply hose, then attach the air supply hose to the
machine. (Check the data plate for the operating pressure range.)
6. Connect the static bond cable to the connector on the hose and then to the target surface.
7. Turn air supply on and allow the air hose to pressurize.
8. Plug the power cord into an electrical outlet. If an extension cord is necessary, it must
comply with the power requirements of this unit and all governing electrical codes. (Check
the data plate for the operating voltage range.)
9. Turn the Control Panel Power Switch on and ensure the Disable Blast button is
13