Frame Base - Grizzly G8712 Instruction Sheet

Assembly (G8712)
to avoid injury when completing these steps,
please get the help of an assistant. When
completed, your new engine crane will look like
the one shown in (figure 3).
figure 3. model g8712 ready for use.
To assemble your crane:
Note: All fasteners must be kept finger tight until
final assembly.
1.
insert the two legs into the frame base
(figure 4), and secure them in place with the
four eye pins and cotter pins.
Note: Each leg has two pins and three pin
holes in the frame base (Figure 4). Pin 1 is
the pivot pin and remains in hole A. Pin 2
is the removable lock pin—when inserted in
hole B, the leg is locked in the down position.
When the Pin 2 is inserted in hole C, the leg
is locked in the raised position.
Frame
base
pin 1
pin 2
figure 4. base assembly.
g7812/g7813 engine Crane
C
A
b
2.
position the main support post onto the base
(figure 5), and secure it in place with two
m14-2 x 100 hex bolts, washers, and nuts.
support
strap
main
support
post
Frame
base
figure 5. main support assembly.
3. install both support straps on the main support
post (figure 5) with two m16-2 x 120 hex
bolts, washers, and nuts.
4.
Connect both support straps to the frame
base (figure 5) with two m14-2 x 110 hex
bolts, washers, and nuts.
-5-