Table of Contents
Advertisement
6. Gather six 5/16" x 1" bolts part # S-7009, 5/16" washers part #
S-7005, and 5/16"-18 nuts part # S-8452 from the hardware
pack. Fasten two 5/16" bolts loosely to the "T" and the hous-
ing, one to each side. Remove board from its position.
7. Get one 1" shaft part # 16-0005, two pillow block bearings part
# 16-0076, four 3/8" x 1-1/2", four 3/8"-16 nuts part # S-8452,
and four 3/8" washers part # S-7021 from the hardware pack.
Slide the two pillow block bearings onto the shaft, have the
allen screw collars facing each other inwards. Insert bolt
through bearings and into the bearing mount plate, loosely fas-
ten.
16
Advertisement
Table of Contents
