Table of Contents
Advertisement
10. Cut a board to approximately 50". Wedge this board into the
orifice of the fan. This will even out any settling that may have
occurred during shipment. Spin the prop until one blade points
directly down. Measure from the blade to the edge of the ori-
fice. Move the bottom leg of the motor mount assembly "T"
until this measurement reads 7.5". Spin the bottom prop until
that same blade is facing straight up, and than measure again.
When the 7.5" measurement is established, secure the bottom
leg with the 5/16" bolts. Spin the prop and insure a consistent
gap between the tips of the blades and the wall of the orifice
housing.
19
Advertisement
Table of Contents
