Osd8816B Operation; Osd8816Bt And Osd8816Br Operation - Optical Systems Design OSD8816B Series Operator's Manual

OPTICAL SYSTEMS DESIGN
2.3

OSD8816B OPERATION

2.3.1

OSD8816BT AND OSD8816BR OPERATION

When using the OSD8816B for the first time, check that the unit is in good condition with no visible
damage.
If a card version is used, insert it in an appropriate slot on the OSD370 or OSD350 chassis and check
that the indicators illuminate accordingly on power up (see Table 5). If a module version (OSD8816BC)
is used, connect the unit to an appropriate power source and check that the indicators illuminate
accordingly on power up (see Table 7).
To connect a video signal, connect a BNC terminated coaxial cable from the camera to the
OSD8816BT. If the camera is operational, the "Video Present" indicator should illuminate 'Amber'.
Connect a BNC terminated coaxial cable between the BNC socket on the rear of the OSD8816BR and
the video monitor or switcher.
Plug in the optical connectors of the optical cable. If the set-up is connected correctly, the OSD8816BR
"Link OK" LED will change from 'Red' to 'Green'. If a video signal is being received the "Video
Present" indicator on the OSD8816BR should be 'Amber'; if no video signal is being received this
indicator will not be illuminated.
Plug the digital signal source (data) into 8 way terminal block connector on the rear of the module.
Ensure that the correct signals are connected to the correct pins of Data Input/Output connector as
specified in Table 3.
Ensure that both OSD8816BT and OSD8816BR switch settings are in the same modes (see Table 4).
DOC ID: 10115503
PAGE 14
OSD8816B OPERATOR MANUAL