Advertisement
Install
The next steps are done on the TSM800 or TSM1330
Make sure that the configuration in use has been backed up – either on the IPG100 or on a USB
Flash drive. We will be completely erasing the disk on the TSM800 or TSM1330
Switch the TSM800 or TSM1330 off.
Plug the new USB flash drive into the TSM800 or TSM1330, and a USB keyboard
Power on the TSM800 or TSM1330 and press the "Del" key as soon as the BIOS splash screen
appears; this should put you into the BIOS settings screen.
Using the left and right arrow keys on the keyboard, select the Boot menu at the top of the
screen.
Using the up and down arrow keys, select the Hard Disk Drives sub-menu. Press Enter to display
the Boot Hard Disk Drives screen.
Using the up and down arrow keys, highlight the 1st Drive and press "Enter" to display the
options menu. Using the up and down arrow keys, elect the USB option corresponding to the
new USB flash drive and press "Enter".
Press F10 to Save Changes and Exit to save the changes and restart the computer. Press Enter
when OK is highlighted to confirm the action.
The computer should boot to a blue Maretron Screen
Page 5
Advertisement
