Table of Contents
Advertisement
DO NOT operate the welder if it or the cables are damaged.
DO NOT hold or touch the pieces to be welded. All workpieces must be suitably clamped.
DO NOT place your hands near the electrodes - danger of burning and/or crushing.
The operator must be fully trained in the use of the welder and must be aware of the potential dangers.
The work area must be closed off in order to keep non-essential persons at a safe distance from the welding operation. Persons within the
work area are subject to the same dangers as user.
Remove ties, watches, rings and other jewellery and contain long hair.
DO NOT use the welder for any purpose other than that for which it is designed.
DO NOT use the welder in damp or wet locations, or outside when raining or snowing.
dANGER! dO NOT weld near inflammable materials, solids, liquids, or gases.
DO NOT operate welder while under the influence of drugs, alcohol or other medication, or if tired.
DO NOT touch newly welded parts as they will be hot.
DO NOT pull the welder by the cable, or the welding clamp.
When not in use, switch off machine and remove the plug from the power supply. Store in a safe, dry location.
1.3 .
ELECTROMAGNETIC FIELDS
When operating, the spot welder produces a very intense electromagnetic field which could cause malfunctions and/or damage to the following:
Pace makers
Magnetic cards
1.4 .
ELECTROMAGNETIC COMPATIBILITY
Spot welding equipment which is connected to a public electricity supply can cause radio frequency interference (e.g. poor radio/television
reception) for other supply users.
2.
INTRODUCTION
Microprocessor controlled, single phase, stud and spot welder machine with automatic torch recognition. Suitable for the professional body shop.
Push-button control of welding functions and setting of the material thickness selects a pre-programmed welding time for consistent weld
quality. Ideal for all types of single-sided steel body repair techniques including the use of studs, nails, washers and wavy-wires.
Supplied with welding-gun mounted slide-hammer for fast dent removal and also studder kit. Set also includes carbon rod for heating and
re-tempering spot repairs. May also be used for double-sided spot welding with optional guns. Trolley (120.803002) also available.
3.
CONTENTS & SPECIFICATION
Unpack the product and check that there are no missing or damaged parts. If you do experience a problem contact your supplier immediately.
Your kit should consist of the following: Electrospot welder, earthing cable with bracket, studder gun with cables, slide hammer and
accessory box of standard electrodes / rivets etc. For contents of box see fig.3.
SPECIFICATIONS:
Power supply . . . . . . . . . . . . . . . . . . . . . . . . 400V - 1ph
Enclosure protection rating. . . . . . . . . . . . . . . . . . . IP22
Input
Max welding power (S max). . . . . . . . . . . . . . . .16.2kVA
Rated power at 50% (Sn). . . . . . . . . . . . . . . . . . . . 4kVA
Mains supply delayed fuses . . . . . . . . . . . . . . . . . . . 16A
Output
Secondary no-load voltage (U
Max spot welding current (I
max) . . . . . . . . . . . . . 3000A
2
Capacity:. . . . . . . . . . . . . . . . . . . . . . .max. 1.5 + 1.5mm
Metallic prostheses
Instrumentation
Electrospot7001
max). . . . . . . . . . . . 5.4V
0
Electrospot7001 with optional
trolley (part no.120.803002)
Watches
Data transmission systems or local telephone lines
Original Language Version
ELECTROSPOT7001 Issue: 2 - 09/03/10
Advertisement
Table of Contents
