Table of Contents
Advertisement
General
Information
Important Note: Environmental scientists have found evidence that
refrigerant emissions contribute to depletion of ozone in the upper
atmosphere and can increase global warming. Trane encourages every
effort to eliminate, if possible, or vigorously reduce the emission of CFC,
HCFC and HFC refrigerant to the atmosphere that can result from
installation, operation, routine maintenance, or major service on this
equipment. Only technicians with EPA certification should be allowed to
handle CFC, HCFC or HFC refrigerants. Compliance or certification to other
local or state codes may also be required when handling refrigerants. Always
act in a responsible manner to conserve refrigerants.
Model Number Description
All Trane products are identified by a multiple-character model number that
precisely identifies a particular type of unit. An explanation of the
alphanumeric identification code is provided in Figure 1a. Its use will enable
the owner/operator, installing contractors, and service engineers to define
the operation, specific components, and other options for any specific unit.
When ordering replacement parts or requesting service, be sure to refer to
the specific model number, serial number, and DL number (if applicable)
stamped on the unit nameplate.
Unit Nameplate
The ChillerSource unit nameplate is located on the panel adjacent to hinged
chiller control panel door. It includes the model number, serial number,
electrical characteristics, refrigerant charge, as well as other pertinent data.
A Mylar and small metal chiller nameplate with the Model Number, Serial
Number, and Unit Weight is located on the outside upper right corner of the
control panel door. An additional nameplate is located on the inside of the
control panel door. See Figure 1b.
When ordering replacement parts or requesting service, be sure to refer to
the specific model number, serial number, and DL number (if applicable)
stamped on the unit nameplate.
Evaporator Barrel Nameplate
The nameplate is located on the top of the evaporator barrel near the supply-
end tube sheet. The word "Nameplate" is stenciled on the insulation. To view
the nameplate, remove the tape over the area and spread the insulation. Re-
tape the insulation after viewing.
Compressor Nameplate
The nameplate for the "Scroll" compressors are located on the compressor
lower housing.
CSRA-SVX02A-EN
5
Advertisement
Table of Contents
