Table of Contents
Advertisement
Quick Links
VENT FrEE / FluElEss
Gas FirEplacE
iNsTallaTioN & opEraTiNG
InstructIon Manual
Please read these instructions carefully before
installation, use and retain them for future reference
LP GAS
VFDG 700 / 800
These appliances conform to the requirements of SANS 1539:2017
LPGSA Permit Number: 1013-40/1-RSA-12-A
Advertisement
Table of Contents
Related Manuals for CHAD-O-CHEF VFDG 700
Summary of Contents for CHAD-O-CHEF VFDG 700
- Page 1 Gas FirEplacE iNsTallaTioN & opEraTiNG InstructIon Manual Please read these instructions carefully before installation, use and retain them for future reference LP GAS VFDG 700 / 800 These appliances conform to the requirements of SANS 1539:2017 LPGSA Permit Number: 1013-40/1-RSA-12-A...
- Page 2 CONGRATULATIONS o n y o u r p u r c h a s e o f a CHAD-O-CHEF FirEplACE W E L C O M E a n d t o t h e CHAD-O-CHEF family...
-
Page 3: Table Of Contents
TAbLE OF CONTENTS General Instructions and Safety Notes ....................1 Specifications................................2 INSTALLATION REQUIREMENTS ......................2 INSTALLATION INSTRUCTIONS ......................3 FOR QUALIFIED GAS INSTALLER ......................3 NG6801 VALVE: Operating Instructions .....................4 NG6801 VALVE: Pressure Testing ......................4 Checklist For Gas Installer ..........................5 Caution ...................................5 Warnings ..................................6 Cleaning ..................................7 Servicing ..................................7 Guarantee Claim Form .............................8... -
Page 4: General Instructions And Safety Notes
GENERAL INSTRUCTIONS AND SAFETY NOTES Thank you for purchasing your new CHAD-O-CHEF Gas Fireplace manufactured to high standards and tested for compliance with SANS 1539:2017 The manufacturer and /or its agents and distributors will not be held responsible for injuries or damages caused by faulty or incorrect installation or use of the appliance. -
Page 5: Specifications
SPECIFICATIONS Model VFDG700 / 800 Gas type Operating pressure 2,8kPa Min Regulator size to comply with SANS 1237 2 kg/hr Max. gas consumption 0.79 kg/hr Max. mJ input 39.5 mJ/hr Max. kW input 11 kW/h Gas inlet connection Ø8mm compression Ignition Piezo Spark Oxygen depletion system ( Pilot ) -
Page 6: Installation Instructions
INSTALLATION INSTRUCTIONS FOR QUALIFIED GAS INSTALLER Unpacking Carefully undo strapping to separate loose parts and remove all plastic protective sheeting. Positioning and Sizing Confirm that the size of Fireplace chosen is the right size for the room. build up a masonry platform to the customers design, with a suitable hole to drop the fireplace into, so that it rests on the surrounding rim. -
Page 7: Ng6801 Valve: Operating Instructions
NG6801 VALVE: OPERATING INSTRUCTIONS The ODS pilot is situated on the side of the burner. The gas control valve is accessible by removing the lower door. Grip both sides and slide the door up. 1. Push in and turn the control knob to the pilot position and hold it there for a few seconds to allow the gas to feed to the pilot. -
Page 8: Checklist For Gas Installer
& the white decorative stone (if applicable) surrounding the burner. … Ensure that the coals or pebbles supplied by Chad-O-Chef are placed as recommended with a 10mm gap between them. … DO NOT use more coals or pebbles than recommended and supplied. (See Page 2) …... -
Page 9: Warnings
WARNINGS WARNING This appliance shall not be installed in bedrooms or bathrooms. WARNING This is an un-vented gas heater. It uses air (oxygen) from the room in which it is installed. Provisions for adequate ventilation must be provided. Refer to appropraite section of the user manual. WARNING CARBON MONOXIDE POISONING CAN LEAD TO DEATH... -
Page 10: Cleaning
CLEANING Should soot deposits appear on the stainless steel, first clean with a dry cloth when cold, and follow up with a cloth dampened with methylated spirits and a final buffing with a dry cloth. Do not use an oil based cleaner, as the oil tends to discolour the stainless steel when heated. -
Page 11: Guarantee Claim Form
Guarantee Claim Form The Guarantee given by Chad-O-Engineering (Pty) Ltd covers the working components, on all Chad-O-Chef Gas Fireplaces for the period of 2 Years (+ 1 Year t’s & c’s apply), covering manufacturing defects caused in the manufacturing process. This does not cover component malfunction if the product is not installed by a registered Gas Installer, or the product is modified after leaving the factory. - Page 12 Manufactured By: Chad-o Engineering PO box 986 Honeydew 2040 Tel: (011) 668 1910 Email: Sales@chad-o-chef.co.za www.chad-o-chef.co.za Version 01...