General MDF15 Operator's Manual page 29

2) Disconnect the Long Reach Air Tool from the Air
Caddy (if so equipped).
3) Remove the accessory tool (if so equipped).
4) Clean all accumulated dirt and grease from the Long
Reach Air Tool and accessory tools utilizing an
appropriate solvent.
Observe all applicable safety precautions for the
solvent.
5) Check all visible parts for wear, breakage or
damage. Order any part required to make the
necessary repair. This will avoid a needless delay
when operating the Long Reach Air Tool at next use.
6) Fill the Long Reach Air Tool with one ounce of
pneumatic tool lubrication oil conforming to ISO 3498
HM.32. Allow the oil to properly circulate within the
internal mechanisms. This will prevent the formation of
rust and/or corrosion on internal moving components.
7) Store the Long Reach Air Tool inside. If the Long
Reach Air Tool must be stored outside, protect it with a
suitable covering. Outside exposure to the elements
can significantly reduce the service life of the air hose
assembly.
Specifications
Application: MDF15 Long Reach Air Tool
PISTON BORE
PISTON STROKE
RATED AIR PRESSURE
OPERATING AIR PRESSURE RANGE 60 to 90 PSI
(400-600 kPa). Lower pressure values may not
produce required performance for any specific job
application.
RATED AIR CONSUMPTION
ENERGY PER BLOW @ RATED
AIR CONSUMPTION
MDF SERIES LONG REACH AIR TOOLS FORM GOM6019801, VERSION 1.0, AUTHORIZATION: DVR, PAGE: 27
.72 inch (18.5 mm)
1.77 inch (45 mm)
90 PSI (600 kPa)
6 CFM (3.0 lit/sec.)
5.0 ft. lbs. (3.6 J)
AND PRESSURE
BLOW FREQUENCY @ RATED
AIR CONSUMPTION
AND PRESSURE
Frequency rates will decrease with reduced
air consumption and pressure values.
CONNECTING HOSE CONFIGURATION
(9.5 mm) diameter, 60 inch (1524 mm) nominal
length. Quick type connecting coupler not furnished.
ACOUSTICAL PRESSURE LEVEL, Lp dB(a) CEE
89/392
ACOUSTICAL POWER LEVEL, Lwa dB(a) CEE
85/409
VIBRATION LEVEL PER ISO 8662-5 Less than 8.3
ft/Sec2 (2.5 m/sec2).
BARREL CONSTRUCTION
ACCESSORY TOOL RECEIVER
CONSTRUCTION
ACCESSORY TOOL
HEXAGON CONNECTION
OVERALL LENGTH (LESS
ACCESSORY TOOL)
LUBRICATION OIL Air tool type conforming to ISO
3498 HM.32. Other approved lubricants include: Shell
Clavus 25, BP Energol LPT 80, Esso
Zerice 46 and Mobil Almo 525.
WEIGHT (LESS
ACCESSORY TOOL)
Application: MDF35 Long Reach Air Tool
PISTON BORE
PISTON STROKE
RATED AIR PRESSURE
OPERATING AIR PRESSURE RANGE 60 to 90 PSI
(400-600 kPa). Lower pressure values may not
produce required performance for any specific job
application.
RATED AIR CONSUMPTION 10.8 CFM (5.0 lit/sec.)
3700 blows per minute.
3/8 inch
Aluminum
.371 inch Industry Standard
55 inch (1397 mm)
10 lbs. (4.5 kg)
.87 inch (22 mm)
1.97 inch (50 mm)
90 PSI (600 kPa)
94
102
Steel