Table of Contents
Advertisement
3. Use the rinse function until soap appears on the
nozzle (5). Close the tank with the cover.
4. Press the key "+" to switch on the dispenser. The LC
display (2) is illuminated in blue.
5. Use the adjustment keys "+" and "-" (3) to setup the
desired dispense amount. Three droplets on the left
display "DISPENSE AMOUNT" indicate maximum
amount while one droplet indicates the lowest
amount.
6. Hold the palm of hand under
the soap nozzle (5). The
sensors (4) and (8) recognize
this and start dispensing the
soap. The display is illumi-
nated in blue for a few se-
conds.
switches back to standby
mode. The backlight of the
display goes out. Once the
hand is held under soap nozzle again, soap is dis-
pensed according to the set amount.
Switching off
Usually the device remains in standby mode so you
have hands-free access to soap all the time; However if
you do not need the device for a longer period of time,
you can switch it completely off as follows:
The
device
Using
then
11
Advertisement
Table of Contents
