Modular Simpli-Flex SFP2000 Instructions For Use

S
F -
IMPLI
PORTION CUP DISPENSER
FOR IN-COUNTER MOUNTING:
REFER TO CHART AND DIAGRAM TO ESTABLISH
MOUNTING HOLE SIZE AND MINIMUM CLEARANCE FOR
EASE OF INSTALLATION AND SERVICE. ALLOW AT LEAST
1/4" (6.35 mm) BETWEEN DISPENSERS (DIMENSION "A")
1. Lay out and cut hole(s) for dispenser.
2. Remove clamp ring (1), gasket (2), pusher (3), and spring (4). (See Figure 1)
3. Pre-drill holes for #8 x 3/4" mounting screws (6). Slide dispenser into
hole and secure through keyhole slots with screws provided.
4. Reassemble dispenser.
LOADING THE DISPENSER:
Your Modular SIMPLI-FLEX dispenser is completely self-adjusting.
1. Unwrap cups and gently push into completely assembled dispenser tube.
(See Figure 2)
DISASSEMBLY: (Refer to Figure #1)
1. Remove decorative clamp ring.
Peel off gasket from lip of dispenser.
2.
NOTE: CAUTION when removing gasket, pusher may be under small amount of spring tension.
3. Remove pusher from spring.
Remove spring from dispenser.
4.
REFERENCE DIMENSIONS
13700 Broadway Ave.
Cleveland Ohio 44125-1992
Phone: 216/587-3400
Fax: 216/587-0733
www.tomlinsonind.com
a
Tomlinson Industries 2000
b
LEX SFP2000
b
INCHES (METRIC)
A
B
C
D
b
b
CLEANING THE DISPENSER:
Your Modular SIMPLI-FLEX dispenser is designed to provide
an easy means of dispensing. The dispenser can be disassembled
without tools to make regular cleaning simple!
Please clean dispenser before use. Regular cleaning will prolong
the life of the dispenser, keep it looking new and ensure sanitary
dispensing.
1. Remove dispenser from mounting location.
2. Remove clamp ring (1), gasket (2), pusher (3), and spring (4).
(See Figure 1)
3. Clean clamp ring and gasket in hot, soapy water. Air dry.
NOTE: these parts are dishwasher safe.
4. Rinse dispenser tube and wipe with a non-toxic cleaner/sanitizer.
5. Reassemble dispenser in reverse of above.
SFP2000
4-11/16 (119.05mm)
14.00 (355.6mm)
3-5/8 (92.08mm)
3-3/4 (95.25mm)
b
MOUNTING HOLE
DIAMETER