Storm Window Requirements - GE AJCM08ACD Owner's Manual And Installation Instructions

STORM WINDOW REQUIREMENTS

2
A storm window frame will not allow the air
conditioner to tilt towards the outside and will keep
it from draining properly. To adjust for this, attach
a piece of wood to the stool.
1/2" higher
than frame
Storm
window
frame
REMOVE AIR CONDITIONER FROM CASE
3
Remove the front grille. See the Care and Cleaning
A
section.
Find the locking plate located on the front
B
left side.
Remove the screw and the locking plate to unlock
C
the air conditioner.
Locking
plate
Remove
screw
D
Remove and discard the shipping screw
on the back of the air conditioner to allow
removal of the air conditioner from the case.
Remove
screw
E
Pull the bottom corners of the air conditioner
and slide it out of the case.
Installation Instructions
Wood
Stool
WOOD PIECES
WIDTH: 2"
LENGTH: Long enough to fit inside the window frame.
THICKNESS: To determine the thickness, place a piece
of wood on the stool to make it 1/2" higher than the top
of the storm window frame.
Attach securely with nails or screws provided by
the installer.
Remove all shipping pads (if present) inside the air
F
conditioner next to the compressor.
Remove the rear grille that is taped to the back
G
of the case. Remove the packet of screws taped
to the back of the grille. While holding the grille at a
45° angle, insert it into the clips at the top of the case
and push the bottom in. Keep slight upward pressure
on the grille until it fits flush with the bottom of the
case.
If attaching the grille
from the outside of the
case, use the 2 long screws.
Clips
Insert the 2 long screws
on the outside
17
Remove shipping pads
(if present)
If attaching the grille
from the inside of the case,
use the 2 short screws.
Insert the 2 short screws
on the inside