MiTAC MP1-11TGS Getting Started With

AWS Greengrass - Getting started with
MP1-11TGS
Table of content

1 Connecting the device ................................................................................................ 1

2. Accessing the device via ssh ...................................................................................... 1

3. Configuring the device for AWS IoT Greengrass ........................................................ 2
1 Connecting the device
- Connect the power-supply of the MP1-11TGS.
- Connect LAN cable to LAN port of the MP1-11TGS, and the LAN cable also connect
to a DHCP switch (this DHCP network can access to Internet)
- Connect LAN cable to your
switch (this DHCP network can access to Internet)
- Power on the device
2. Accessing the device via ssh
The IP-Address of the LAN-interface of the MP1-11TGS is set to: 192.168.2.100/24
Configure your PC to use following network settings on the LAN-interface connected
to the MP1-11TGS:
IP-Address: 192.168.2.2
Subnet-mask: 255.255.255.0
You can use a standard SSH-Client to access the MP1-11TGS.
In this example we will use PuTTY (https://www.putty.org/)
Start the SSH-Client and enter the MP1-11TGS IP-Address into the text-field. Make
sure that the radio-button next to 'SSH' is checked to configure the software to use
port 22 for connection
PC, and the LAN cable also connect to the same DHCP