Advertisement
MAINTENANCE
Bearing Maintenance - The Class 5 A.B.E.C. bearings in the Boss Xtreme are teflon impregnated in the ball bearing race; thus,
no lubrication is needed for these bearings.
NOTE: Do not lubricate the two small weep holes on the bottom of the reel. These holes are for water to drain out of the reel.
Wash down your Boss reel with fresh water after each use. We recommend lightly spraying it to prevent water from being forced inside. If heavy
pressure is needed put the reel in the "Full" drag position. Do not completely submerge the reel into water. Wipe the
exterior parts with an anti-corrosion lubricant. We recommend Corrosion-X® by Corrosion Technologies. Use Corrosion-X® to
lubricate all the parts indicated with the oil
Periodically, check all exterior screws to make sure they are tight. Screws may loosen over time with boat vibrations.
We recommend yearly maintenance of your Boss reel with a service professional. Preventative maintenance of your Boss reel will keep the inter-
nal parts in proper working condition and prolong the life of the reel.
Storage - When storing your Boss reel, put the reel in "Free Spool" and the clicker in the on position.
For further details on maintaing your
Accurate Boss Reel, please visit Tech
Support at our web site:
www.accuratefishing.com/support.php
symbol.
Oil
Preset Knob
Clicker on/off
Main Drag Lever
pursuetheoutdoors.com/schematics
Four Torx Screws
Strike Button
(Applies to BX2 Reels Only)
Handle Shaft
(Handle Nut must be removed)
Free-Spool Button
Handle Knob Pin
High Speed Button
Low Speed Button
7
Advertisement
