Technical Specifications - Intec I-Starter 2.8 User Manual

5. Turn the ignition key for a maximum of 3 seconds and then wait for a further 3
minutes before attempting to jump start again.
6. When the engine is running, remove one clamp at a time, return the clamps to their
housing and recharge the starter as soon as possible.
Note: when the push button BOOST is pressed, the security function of the device is
inhibited for 30 seconds. Once the engine has been jump started, the cables must be
quickly disconnected from the battery in order not to overload it.
Charging of cell phones and tablets
1. Plug the switch cable to Quick Charge output port.
2. Select appropriate connector and connect it to your mobile phones or tablet.
3. Touch the switch button, it can recognise eletronic products's suitable parameters,
start to charge for mobile phone/tabletc etc.
Use of the LED lamp
Press the switch 3 seconds to start the LED flash light.
There are 4 modes of LED light appear in order (normal, strobe. SOS, off) if you press
slightly.

TECHNICAL SPECIFICATIONS

Lithium Battery Capacity (LiPo)*
Outputs
Input socket
Recharge time
Cranking Ampere
Peak Ampere
Operating temperatures
Sizes
Weight
(*) Lithium polymer Battery
13000 mAh (48.1 Wh)
5V-2.1A; Quick Charge (5V-2.4A; 9V-2A;
12V-1.5A); 12V jump start
Quick Charge 5V / 9V
About 3 hours
500A
1500A
-20°C / 60°C
151x81x32 mm
440 gr
English
13