Intec I-Starter 2.8 User Manual page 12

English
Emergency start
1. The device must be properly charged, with the four blue LEDs of the indicator
switched on.
2. Connect the red clamp to the positive terminal (+) of the battery, or to the remote
positive pole. Connect the black clamp to the negative pole (-) of the battery or to
the remote negative pole.
3. The connection must be realized with both sides of the clam firmly attached to the
metal. In case of sulphur deposits on the pole, these must be previously removed.
4. Check the LED status on clamps box following below panel:
Led Status
GREEN ON
GREEN FLASHING
BOTH OFF
RED ON (1)
RED ON (2)
RED ON (3)
RED FLASHING
RED AND GREEN
FLASHING
RED ON AND BUZZER
(*) Jumpstarter enters auto-protection mode when used more than 4 times in 10 minutes.
12
Indications
Ok, you can start the vehicle
Vehicle battery is deeply
discharged
Vehicle battery at 0V or
removed
Over-Temperature protection
The jump starter is in low
voltage
Connection is not good
Over-Current protection
More than 4 jumps in 10
minutes*
Reversed polarity
Solutions
Press BOOST 2 sec. When
green LED on start the
vehicle
Press BOOST 2 sec. When
green LED on start the
vehicle
Cool down the Jumpstarter
Charge the jumpstarter
Make a better connection on
battery poles
Wait 30 sec. and start again
Wait 10 minutes and start
again
Check + (Red) and – (Black)
connections