Advertisement
IJ3000
Revision H
ITEM
PART NUMBER
1
5760-366
2
5760-432
3
5760-474
4
5
5081-010
6
7
5081-705
8
5151-124
1
IJ384 / IJ352 Print Head Roller Bracket Mounting Kit
DESCRIPTION
KIT,BRCKT,CNVYR MNT,SINGLE IJ PH
BRACKET,RETRACTING,IJ PH
ROLLER BRACKET ASSEMBLY, IJ384
SCR,1/4-20 X 5/8 SOC HD CAP,SS
SCR,#10-32 X 3/8 SOC HD CAP,SS
SCR, #8 SELF TAPPING
2
5
Assembly Instructions
QTY
1
1
1
2
4
4
© 2010 Illinois Tool Works. All rights reserved.
Service Part Kit 5760-810
5760-810N
Page 1 of 3
Printed in USA
Advertisement
Table of Contents
Related Manuals for ITW Diagraph IJ3000
Summary of Contents for ITW Diagraph IJ3000
- Page 1 IJ3000 IJ384 / IJ352 Print Head Roller Bracket Mounting Kit 5760-810N Revision H Assembly Instructions Page 1 of 3 ITEM PART NUMBER DESCRIPTION 5760-366 KIT,BRCKT,CNVYR MNT,SINGLE IJ PH 5760-432 BRACKET,RETRACTING,IJ PH 5760-474 ROLLER BRACKET ASSEMBLY, IJ384 5081-010 SCR,1/4-20 X 5/8 SOC HD CAP,SS 5081-705 SCR,#10-32 X 3/8 SOC HD CAP,SS 5151-124...
- Page 2 IJ384 / IJ352 Print Head Roller Bracket Mounting Kit IJ3000 5760-810N Page 2 of 3 Assembly Instructions Revision H Installation notes: 1. Adjust the vertical position of the leading upper roller such that it will make contact with the carton (this is critical when printing on a tray pack).
- Page 3 IJ3000 IJ384 / IJ352 Print Head Roller Bracket Mounting Kit 5760-810N Revision H Assembly Instructions Page 3 of 3 Using the roller bracket alignment tool (5760-815): 1. Loosen the four screws holding the roller bracket onto the print head. 2. Assemble alignment tool to the print head nose using the captive screws. The press nuts should face the print head nose creating the proper gap between the rollers and the print head nose (see figure 2).
Need help?
Do you have a question about the Diagraph IJ3000 and is the answer not in the manual?
Questions and answers