Download  Print this page

Connecting The Reader/writer To A Computer - Sony MRW62E-S2 Operating Instructions Manual

Multi-card reader/writer.
Hide thumbs


Connecting the
Reader/Writer to a
Simply connect the reader/writer to a
computer using the supplied USB cable.
Start the computer.
Connect the smaller connector
of the USB cable to the USB port
on the rear of the reader/writer.
Connect the larger connector of
the USB cable to the USB port on
the computer.
The computer recognizes the reader/
writer as a removable disk, and the
reader/writer is ready for use.
• Do not connect to a computer via a USB hub.
• Depending on the computer and the status of its
operating system, the reader/writer may not
operate or may become unstable. If this occurs,
refer to the "Troubleshooting" section.
• After disconnecting the USB cable, wait at least
5 seconds before reconnecting it. (Otherwise, the
reader/writer may not be recognized.)
• When two or more USB devices are connected to
one computer, the reader/writer is not guaranteed
to operate simultaneously with some types of
USB device.
• You cannot access two or more memory cards
simultaneously on a single computer by
connecting additional memory card devices.
Remove any memory cards from the reader/
writer or turn off the other devices.
x For Windows
• On some computers, a message may appear
asking you to insert the operating system
disc. When this happens, follow the
computer's instructions.
• On some computers, the "HI-SPEED USB
Device Plugged into non-HI-SPEED USB
Hub" message may appear, indicating that
a hi-speed USB device has been connected
to a USB port which does not support hi-
speed USB. If your computer has multiple
USB ports, try connecting to a different
Otherwise, close the message and continue
using the reader/writer with the current


Table of Contents

   Related Manuals for Sony MRW62E-S2

Comments to this Manuals

Symbols: 0
Latest comments: