Table of Contents
Advertisement
Notes
• If you connect a monaural VCR, connect the yellow plug to
jack) and the black plug to -L (MONO) (the white jack).
• If you connect a VCR to the ˘ (antenna) terminal, preset the signal
output from the VCR to the program number 0 on the TV.
• If both
(S video input) and ... 1 (video input) at the rear of your TV
are input at the same time, the
selected. To view ... 1 (video input), disconnect the S video cable.
• When no signal is input to the connected video equipment, the TV screen
becomes blue.
Step 2
Insert the batteries
into the remote
Note
• Do not use old batteries nor use different types of batteries together.
Step 3
Preset the channels automatically
Front of TV
1
PROGR
ONE-PUSH AUTOMATIC PROGRAMMING
AUTO PROGRAM
2
AUTO
PR:01
PROGR
TV SYS:AUTO
VHF LOW
ONE-PUSH AUTOMATIC PROGRAMMING
Tips
• If you want to stop the automatic channel presetting, press MENU twice.
• If your TV has preset an unwanted channel or cannot preset a particular
channel, then preset your TV manually (see page 26 and 27).
Now You Are Ready. . .
To preset the channels manually, see
page 26 and 27.
(the yellow
(S video input) is automatically
1
5
Using Your New TV
Connecting the 3D WOOFER
You can enjoy high quality sound by connecting the 3D WOOFER.
3D WOOFER
Rear of TV
1
2
Black wire
(8 )
WOOFER
Red wire
1
Attach the 3D WOOFER into the footholds on the top of your TV.
2
Connect the wires to the 3D WOOFER (8Ω) terminals at the rear of your TV.
The red wire should be connected to the ' red terminal and the black wire
to the ' black terminal.
Notes
• Connect only the supplied 3D WOOFER; otherwise your TV may
malfunction.
• Unplug your TV from the wall outlet when connecting the 3D WOOFER.
• To prevent a malfunction caused by a short circuit of the terminals, make
sure that none of the 3D WOOFER wire strands stick out, making contact
with the neighbouring speaker terminal.
6
Using Your New TV
Advertisement
Table of Contents
