Reznor Nor-Ray-Vac Installation & Operating Manual page 5

17. Select parameter group 13 and
press SEL.
21. Press SAVE
25. Select parameter 2003 In group
20 and press EDIT to change the
parameter valve of the Motor
FLC.
29. Press EXIT 3 times till PARAME-
TERS screen ap-pares.
18. Select parameter 1301 In a
group and press EDIT to change
the parameter valve to suit the
site setting.
22. Select parameter 1401 In group
14 and press EDIT to change the
parameter valve FAULT(-1)
26. Press SAVE.
30. Press LOC/REM button to
change the mode to REM
(remote).
19. Press SAVE.
23. Press SAVE and press EXIT.
27. Select parameter 2007 In group
20 and press EDIT to change
the parameter valve to suit site
setting.
After the whole set-up is completed,
check that there are no faults or alarms
shown on the display and the panel
LED is green and does not blink.
20. Select parameter 1302 In a
group and press EDIT to change
the parameter valve 100.0%
24. Select parameter group 20 and
press SEL.
28. Press SAVE.
5