Advertisement
Test and set-up
IMPORTANT:
Before mounting the PCB into the enclosure, be sure to
•
trim all the leads !
Bend C6 like in the drawing:
•
For adjusting the receiver, a completely plastic tuning
•
screwdriver is needed. This is supplied with the receiver.
The transmitter must be in its housing with cover on, and
•
fitted with a new battery type V23GA or GP23A. Check the
polarity which is shown in the enclosure.
The receiver may not be in the vicinity of a metal object.
•
The transmitter and receiver must have the same code.
•
On the receiver K6707, either jumper lead CH1 has to be
•
mounted in order to be operated by button SW1 (big) of the
transmitter, or jumper lead CH2 has to be mounted for op-
eration by button SW2 (small).
C6
Test & set-up
9
Advertisement
