Test & set-up
1) Use of the new transmitter with the K6707 receiver or
car alarm type K3511
Replace C1 on the receiver with a 1pF capacitor. This
•
capacitor is supplied with the transmitter.
Set the tuning capacitor of the receiver to around its mid
•
position (see fig. 17 in the receiver handbook). Check
that the tuning LED of the receiver is not lit or is only
just lit up, if not set the capacitor slightly differently. Do
not touch the circuit with your hand.
Activate the transmitter and turn the tuning capacitor on
•
the receiver until the receiver tuning LED lights up. If all
is well, the relay should switch if the transmitter and
receiver codes are the same.
For more precise tuning, get someone else to activate
•
the transmitter from a few metres away and then fine-
tune the receiver.
Once the receiver has been set to a transmitter, then it will
also be set for other transmitters of the new type.
10