Cleaning And Care - Maxwell MW-2113 BK Manual Instruction

•
•
•
•
•
•
Step 5 – the final part
–
Cone-shaped haircut
Set the necessary attachment comb
and start cutting from the head back
towards the crown. Cut hair against hair
growth from the head front to the crown
and from the sides (pic. 8). To get a flat
top haircut, use the comb: lift the locks
and cut them along the comb. Comb
the hair to reveal uneven locks.
Note: During the breaks between oper-
ations, you can hang the clipper on
the hanging loop (4) having preliminar-
M_MW-2113_100 x140.indd 13
Use the 3 mm attachment comb (5)
and 6 mm attachment comb (6) for
very short haircut. To leave a little
longer hair, use the 9 mm attach-
ment comb (7) or 12 mm attachment
comb (8).
To leave longer hair, grip hair locks
between your fingers and cut the
hair off using the clipper (pic. 5).
You can use the comb: lift the hair
locks and cut them with the hair
clipper above the comb (pic. 6).
Always start cutting from the head
back.
Comb the hair to reveal uneven
locks.
Use scissors to trim hair.
In the final stage of hair cutting
remove the attachment comb from
the unit, turn the blades of the clip-
per towards the hair and trim hair
on the temples and neck carefully.
Do not press the clipper strongly,
there is danger of injuries or cuts
when open blades come in contact
with skin (pic. 7).
ily switched the unit off with the power
switch (1).
After you finish cutting hair, switch
the hair clipper off setting the power
switch (1) to the position «OFF» and
take the power plug out of the socket,
put the protective cover (9) on the
blades (2, 3).

CLEANING AND CARE

Lubricating the blades
Regularly lubricate the blades using the
oil (10) supplied with the unit.
–
Switch the unit off using the power
switch (1) and unplug it.
–
Apply one-two drops of oil (10) on
the teeth of the blades (2, 3) and
the back side of the upper blade (3),
switch the unit on and make sure
that the blades are moving smooth-
ly.
–
Switch the unit off, clean the excess
oil with a dry cloth.
Attention! Use only the oil supplied
with the unit.
DO NOT USE vegetable oil, fat, oil
mixed with any solvents for lubricating.
Solvents will evaporate, leaving thick
grease that may slow down the blades'
motion.
Cleaning the hair clipper
–
Switch the hair clipper off and
unplug it.
–
Clean the blades from hair, using
the cleaning brush (11).
–
Wipe the accessories and the unit
body with a slightly wet cloth, and
then dry them with a soft cloth.
–
Put the protective cover (9) on the
blades (2, 3).
13
ENGLISH
13.12.2016 9:24:23