Maxwell MW-2113 BK Manual Instruction page 11

•
•
•
Attention! Do not allow children to
play with polyethylene bags or packag-
ing film. Danger of suffocation!
•
•
•
•
THE
HOUSEHOLD USAGE ONLY
USING THE HAIR CLIPPER
–
M_MW-2113_100 x140.indd 11
The unit is not intended for usage
by physically or mentally disabled
persons (including children) or
by persons lacking experience or
knowledge if they are not under
supervision of a person who is
responsible for their safety or if they
are not instructed by this person on
the usage of the unit.
Close supervision is necessary
when children or disabled persons
are near the operating unit.
For children safety reasons do not
leave polyethylene bags used as a
packaging unattended.
Do not attempt to repair the unit. Do
not disassemble the unit by yourself,
if any malfunction is detected or after
it was dropped, unplug the unit and
apply to any authorized service cen-
ter at the contact addresses given in
the warranty certificate and on the
website www.maxwell-products.ru.
Transport the unit in the original
package only.
For environment protection do not
discard the unit with usual house-
hold waste after its service life expi-
ration; apply to a specialized center
for further recycling.
Keep the unit out of reach of chil-
dren and disabled persons.
UNIT IS INTENDED
In case of the unit transportation
or storage at low temperature keep
it for at least three hours at room
temperature.
–
Remove all stickers and packag-
ing elements that can prevent unit
operation.
Blades
–
If the blades have been removed
for cleaning or replacement, install
them back to their places and tight-
en the fastening screws. The unit's
design makes it unnecessary to
level the blades after installing
them.
Lubricating oil
–
To maintain the unit in a good con-
dition, you should lubricate the
blades periodically. Do not use
vegetable oil or oil that includes
solvents. Solvents are subjected
to evaporation, and the remaining
thick oil can slow down the upper
blade (3) moving speed.
–
For lubricating the blades use only
the oil (10) supplied with the unit.
Hair styling instructions
•
Hair should be clean and dry during
hair cutting.
•
Insert the power plug into the mains
socket.
•
Before cutting hair switch the
hair clipper on, moving the power
switch (1) to the position «ON» and
make sure that hair clipper oper-
FOR ates normally and the blades move
smoothly. If there is excess oil on
the blades, switch the hair clipper
off setting the power switch (1) to
the position «OFF» and remove the
excessive oil with a dry cloth.
11
ENGLISH
13.12.2016 9:24:23