Advertisement
M A I N T E N A N C E
SEE AIR PURIFIER OVERVIEW PAGE FOR REFERENCE.
How to Install the Cover
1.
The cover only fits one way. There is a notch in the bottom for the side where the
user interface is located.
2.
Lower the cover onto the air purifier. When properly seated it will be as shown
above.
3.
The key to getting the cover to engage with the safety switch is to ensure the cover
clasp seats with the clasp of the base of the air purifier on the user interface side.
We suggest you lower the cover onto the unit and then lift about one inch. Lower
the cover with the long sides pressed in so the cover rests inside the guides along
the bottom and ensure it seats with the clasps by the user interface. In lifting the
cover up and down you should hear the safety switch click like it's being engaged.
a.
Press in on the long sides so the white cover rests in the guard rails along the
length of the air purifier as shown above. If the cover rests outside the guard
rails it may bend somewhat and may not make contact with the safety switch.
b.
Clasp the latches on the user interface side first. You may need to lift up slightly
on the cover and pull back to get both latches to seat as shown below.
c.
The latch from the top cover must rest into the other part of the latch on the
base of the air purifier.
4.
Clasp the two latches on the user interface side first. Then clasp the latches on the
opposite side. If the latches on the opposite side do not latch, lift the cover slightly
(with the user interface side still latched) and re-seat so they can latch properly.
11
Advertisement
