Advertisement
Operation
1.
Turn car radio "ON"
2.
Press "CD" or "CD/TAPE" button on radio until display changes to Fig.
5
CD changer display mode
Note: If radio does not switch to CD, cycle ignition OFF/ON and try again.
3. Put audio device in play mode. If playback is distorted lower the volume
on device OR if inaudible, raise volume on device.
Warning:
You must use smartphone or audio device built-in
controls to access and control music files. The radio buttons will not
control audio device (except volume control)
4. If correct operation is confirmed go ahead and reinstall the Radio.
Fig. 5
Frequent ask questions
1.
Does the HON-AUX work on all Honda Radios?
NO;
The HON-AUX works on select 1992-01 Honda Radios with CD Changer
controls (8-pin port on back of the Radio).
2. My radio has a built-in 6 CD changer, will the HON-AUX Work?
6-CD Changer radios without an 8-pin DIN connector are not supported.
3. Can I use the Radio buttons to control audio device?
NO; the HON-AUX does not control audio device. Use the device built-in
controls to browse music library.
4. What will happen if phone rings while using this adapter
Most phones will mute music playback while in a call and placing phone in
"speakerphone "mode, the callers voice will be heard on car speakers.
5. My vehicle has a slave CD player, will the HON-AUX Work?
The HON-AUX replaces the slave CD player.
*The HON-AUX is not a PIE part offering. This version of the adapter is brought to you by
DiscountCarStereo.com
email support@discountcarstereo.com
©1995-17 Discount Car Stereo, Inc. All rights reserved. Information in this document is subject
to change without notice. Other products and companies referred to herein are trademarks or
registered trademarks of their respective companies or mark holders.
Advertisement
