Sony ICD-UX512 Operating Instructions Manual page 94

1
Slide the USB slide lever on the back of
the IC recorder, and insert the USB
DIRECT connector into the USB port of
a running computer.
2
Make sure the IC recorder has been
recognized properly.
On the Windows screen; open "My
Computer" or "Computer," and make
sure that "IC RECORDER" or
"MEMORY CARD" has been
recognized.
On the Macintosh screen; make sure that
an "IC RECORDER" or "MEMORY
CARD" drive is displayed on the
desktop.
The IC recorder is recognized by the
computer as soon as the connection is
made. While the IC recorder is connected to
the computer, "Connecting" is displayed in
the display window of the IC recorder.
If the IC recorder cannot be connected to a
computer directly, use the supplied USB
connection support cable.
94
GB
USB connection support
cable (supplied)
P Notes
• If you connect more than two USB devices
to your computer, normal operation will not
be guaranteed.
• Use of this IC recorder with a USB hub or a
USB cable other than the supplied USB
connection support cable is not guaranteed.
• A malfunction may occur depending on the
USB devices connected at the same time.
• Before connecting the IC recorder to your
computer, check that the battery is inserted
in the IC recorder.
• It is recommended that you disconnect the
IC recorder from the computer when you are
not using the IC recorder connected to the
computer.