Message List - Sony ICD-SX712 Operating Instructions Manual

Message List

Message
HOLD
Low Battery
Memory Card Error
Memory Card Not Supported • A memory card that the IC recorder does not support is inserted.
Unknown Memory Card
Memory Card Locked
Read Only Memory Card
Memory Card Access
Denied
Memory Full
144
GB
Cause/Remedy
• All the button operations are disabled because the IC recorder is in
the HOLD status to prevent unintentional operations. Slide the
POWER/HOLD switch towards the center to release the IC
recorder from the HOLD status (page 12).
• Batteries are exhausted. Replace the old LR03 (size AAA)
alkaline batteries with new ones. Or charge the rechargeable
batteries (page 14) or replace the old rechargeable batteries with
new ones.
• An error occurred while a memory card was being inserted into
the memory card slot. Remove and try inserting it again. If this
message persists, use a new memory card.
See "About compatible memory cards" on page 49.
• An M2™ that the IC recorder does not authorize is inserted. See
"About compatible memory cards" on page 49.
• The memory card is write-protected. A write-protected memory
card cannot be used with the IC recorder.
• A read-only memory card is inserted. A read-only memory card
cannot be used with the IC recorder.
• Since a memory card containing an access control function is
inserted, you cannot use it.
• The remaining memory capacity of the IC recorder is insufficient.
Erase some files before recording.