Appendix; ❶ Troubleshooting - Canon LV 7365 User Manual

7. Appendix

❶ Troubleshooting
This section helps you resolve problems you may encounter while setting up or using the projector.
Warning indicator
POWer indicator
laMP indicator
Indicator Messages
POWER Indicator
Indicator Condition
Blinking light
Steady light
WARNING Indicator
Indicator Condition
Blinking light
Steady light
LAMP Indicator
Indicator Condition
Blinking light
Steady light
If a temperature error occurs
If the temperature inside the projector rises too high, the over-temperature protector will automatically turn off the lamp with the
WARNING indicator blinking (2-cycle On and Off.)
Should this happen, do the following:
- Unplug the power cord after the cooling fans stop.
- Move the projector to a cooler location if the room where you are presenting is particularly too warm.
- Clean the ventilation holes if they are clogged with dust.
- Wait about 60 minutes until the inside of the projector becomes cool enough.
WARNING
LAMP
Off
Green 0.5 sec On,
0.5 sec Off
2.5 sec On,
0.5 sec Off
Orange 0.5 sec On,
0.5 sec Off
Green
Orange
Off
Red 1 c y c l e (0 . 5 s e c
On, 2.5 sec Off)
2 c y c l e (0 . 5 s e c
On, 0.5 sec Off)
4 c y c l e (0 . 5 s e c
On, 0.5 sec Off)
6 c y c l e (0 . 5 s e c
On, 0.5 sec Off)
Green
Orange
Off
Red
Red
Green
MENU
INPUT
KEYSTONE
AUTO PC
VOL VOL
- +
BACK
Projector Condition
The main power is off
The projector is getting ready
to turn on.
Off Timer is enabled.
T h e p r o j e c t o r i s c o o l i n g
down.
The projector is turned on.
The projector is in Standby.
Projector Condition
Normal
L a mp c ov er er r or or l a mp
housing error
Temperature error
Fan error
Lamp error
Re-firing the lamp (The pro-
jector is cooling down.)
Key lock is on.
Projector Condition
Normal
Lamp has reached its end of life. Lamp
replacement message will be displayed.
Lamp has been used beyond its limit.
The projector will not turn on until the
lamp is replaced.
Lamp mode is set to Quiet mode.
6
Note
–
Wait for a moment.
–
Wait for a moment.
–
–
Note
–
Replace the lamp cover or lamp housing correctly.
( → page 60)
The projector is overheated. Move the projector to a
cooler location.
Fans will not work correctly.
Lamp fails to light. Wait a full minute and then turn on
again.
The projector is re-firing.
Wait for a moment.
You have pressed cabinet button when Key lock is on.
( → page 50)
Note
–
Replace the lamp.
Replace the lamp.
–