Table of Contents
Advertisement
OX-Gen System Installation Instruction Guide
Note: Pliers will be needed for cutting tubing and tightening clamps (tools not included).
Use letter chart below as a guide to connect your OX-Gen Air Pump.
A. Connector Pipe
B. Air Vent
C. Hose Clamp
D. Weighted Vinyl Tubing
E. T Barbed Fitting
F. Manifold Valve
G. Diffuser Disc
For OX-4500 and OX-7000 systems, begin by cutting
(3) 3" pieces of tubing. Connect as shown.
Pg. 6
OX-3500
OX-4500 and OX-7000
OX-Gen Aeration
Advertisement
Table of Contents
