Sony Network Walkman NW-HD3 Operating Instructions Manual page 102

Symptom
The player is not recognized by the
computer when it is connected to
the computer.
Audio data cannot be transferred
to the player from your computer.
The number of tracks that can be
transferred to the player is not
much. (Available recording time
is short.)
Audio data cannot be transferred
back to your computer from the
player.
44
GB
Case and/or corrective action
 The USB adaptor is not connected correctly to the player.
Insert the USB adaptor securely until it reaches to the end
and clicks into place
 The USB cable is not connected properly. Disconnect the USB
cable and then reconnect it.
 A USB hub is used. Connecting via a USB hub is not
guaranteed. Connect the USB cable directly to the computer.
 The driver fi le for the player has not been installed. Reinstall
the SonicStage software for the player using the supplied
CD-ROM (  page 11) to install the driver together.
 The installation of the SonicStage software had been failed.
Disconnect the player and your computer, and then reinstall the
software again using the supplied CD-ROM (  page 11).
 Slide the BUILT-IN BATTERY switch to ON.
 The USB cable is not connected properly. Disconnect the USB
cable and then reconnect it.
 The track has already been transferred to the player three
times. Transfer back the track to the computer to increase the
transferable count (  page 34), and then transfer it to the
player again.
 The free space of the hard disk in the player is insuffi cient.
Transfer back any unnecessary tracks to your computer to
increase the free space (  page 34).
 You have already transferred over 65,535 tracks or over 4,096
groups to the hard disk of the player. Or you have already
transferred over 999 tracks for a group.
 Tracks with a limited playing period or playing count may not
be transferred due to restrictions set by copyright holders. For
details on the settings of each audio fi le, contact the distributor.
 The free space in the hard disk of the player is not enough for
the size of audio data you tried to transfer. Transfer back any
unnecessary tracks to increase the free space (  page 34).
 Data other than audio data is stored in the hard disk of the
player. Move data other than audio data to the computer to
increase the free space.
 A computer other than the one used for transfer to the player is
selected as the transfer target. Audio data cannot be transferred
back to a computer other than the one used for transfer to the
player.
 The audio data has been deleted from computer you used to
transfer to the player. The audio data cannot be transferred back
to your computer if the track is deleted from the computer used
to transfer to the player.
(  page 8).