Download Print this page

Preparing A Power Source - Sony Network Walkman NW-HD3 Operating Instructions Manual

Portable hard disk audio player
Hide thumbs Also See for Network Walkman NW-HD3:

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 59
Preparing a Power
Source
Charge the built-in lithium-ion rechargeable
battery before using it for the fi rst time or
when it is depleted.
1
Slide the BUILT-IN BATTERY switch
to ON.
The protection for the built-in
rechargeable battery is released and power
is supplied to the player. Keep the switch
to ON position.
2
Connect the the AC power adaptor
to the USB adaptor.
Connect the DC plug of the AC power
adaptor to the DC IN jack of the USB
adaptor, and then connect the AC plug to
a wall outlet.
USB adaptor
to DC IN
jack
8
GB
to an AC outlet
AC power
adaptor
3
Connect the USB adaptor to the
player.
Insert the USB adaptor as shown below
until it clicks into place.
Charging of the battery starts. The CHG
lamp lights up on the USB adaptor, and
if the player is on, the battery indicator in
the display changes.
Charging is completed and the CHG lamp
goes off in approximately 3 hours*. The
lightning mark lights up in the display if
the player is on.
To charge quickly, turn the display off and
disconnect the USB cable from the USB
adaptor, and then it takes approximately 1
hour* to charge up to 80%.
* This is the approximate charging time for an
empty battery charged under room temperature.
When the display is on, it takes approximately
5 hours to charge. The charging time will
differ depending on the remaining power and
battery condition. If the battery is charged in a
low-temperature environment, the charging time
will be longer.
USB adaptor connector
USB adaptor
CHG
lamp

Advertisement

loading

This manual is also suitable for:

Nw hd3 - network walkman 20 gb digital music player