Advertisement
INTRODUCTION
Driving on public roads and general transportation safety
Comply with local laws and regulations.
Use appropriate lighting to meet local regulations.
Make sure Slow Moving Vehicle (SMV) emblem is visible.
Use safety chains for trailed equipment when provided with machine or equipment.
Lift implements and attachments high enough above ground to prevent accidental contact with road.
When transporting equipment or machine on a transport trailer, make sure it is properly secured. Be sure the Slow
Moving Vehicle (SMV) on the equipment or machine is covered while being transported on a trailer.
Be aware of overhead structures or power lines and make sure the machine and/or attachments can pass safely
under.
Travel speed should be such that complete control and machine stability is maintained at all times.
Slow down and signal before turning.
Pull over to allow faster traffic to pass.
Follow correct towing procedure for equipment with or without brakes.
Fire and explosion prevention
Fuel or oil leaked or spilled on hot surfaces or electrical components can cause a fire.
Crop materials, trash, debris, bird nests, or flammable material can ignite on hot surfaces.
Always have a fire extinguisher on or near the machine.
Make sure the fire extinguisher(s) is maintained and serviced according to the manufacturer's instructions.
At least once each day and at the end of the day remove all trash and debris from the machine especially around
hot components such as engine, transmission, exhaust, battery, etc. More frequent cleaning of your machine may be
necessary depending on the operating environment and conditions.
At least once each day, remove debris accumulation around moving components such as bearings, pulleys, belts,
gears, cleaning fan, etc. More frequent cleaning of your machine may be necessary depending on the operating
environment and conditions.
Inspect the electrical system for loose connections or frayed insulation. Repair or replace loose or damaged parts.
Do not store oily rags or other flammable material on the machine.
Do not weld or flame cut any items that contain flammable material. Clean items thoroughly with non-flammable
solvents before welding or flame-cutting.
Do not expose the machine to flames, burning brush, or explosives.
Promptly investigate any unusual smells or odors that may occur during operation of the machine.
47848279A 15/02/2017
17
Hide quick links:
Advertisement
