Cleaning And Maintenance; Troubleshooting - Hyundai HC 607 Instruction Manual

INSTRUCTIONS fOR USE
Switch
0 = 0ff
= Cool air
1 = Gentle warm air flow for easy styling
2 = Stronger and warmer air flow for fast styling and drying
Cool Air
Push the switch to position
USES Of THE ATTACHMENT
Changing accessories
Push the button on the side of the curling brush body to the position marked. Remove the accessory
you wish to change. Applying light pressure, push the accessory you require on to the body. Rotate
the body to the position marked . You will hear the accessory click into place.
Removing the accessories:
Press the release button and turn the accesories into position ● and remove it.
Warning: The attachement will inevitably become hot during use. Make sure to let it cool down
before handling.
Use only on dry or nearly dry hair and ensure hair is fully detangled before starting to style. Attach
the required attachment then plug the styler in. Select the desired heat setting to begin styling.
Small roll brush
The small round brush is suitable for styling fine and/or relatively short hair, or for simply brushing
through. The heat spreads evenly through the hair section, making it easy to style. Separate your
hair into sections. Starting at the front, place the brush at the roots and slowly let the brush glide
down the hair section to smooth the cuticle. Continue around the nape, and up to the top of the
head. Style the bottom sections by curling hair around the brush.
The curling iron
Note - Wait for approximate 2 minutes until the attachment has heated up properly before using it.
Take a strand of hair, maximum 3 cm wide, open the curling tong and place the ends of the strand
on the tong and clamp tight by closing the curling tong. Now turn the appliance so that the strand
of hair is rolled up to the roots. Hold the appliance in this position for approximate 20 seconds,
maintaining sufficient distance between scalp and curling tong. Then carefully unwind the strand
half way, open the curling tong and release the curl gently from the tong.

CLEANING AND MAINTENANCE

- Before cleaning, always disconnect the appliance from mains by pulling out the plug.
- The styler can be cleaned with a dry cloth. The brushes can be cleaned with a small bristle
brush or a dry cloth.
- If you use styling mousse, setting lotion or hair spray residue builds up on the attachments.
- You may clean the attachments in lukewarm water. Always detach the attachment from the
appliance first.
- Dry the attachments well before inserting them in appliance.

TROUBLESHOOTING

The device is not working
- Check that the mains connection cable is firmly plugged in.
- Check the right positions of the On/Off switch.
and your airstryler will be with cool air.
ENG - 20