Table of Contents
Advertisement
Optional Components
Hooking up optional components
To enhance your system, you can connect optional components. Refer to the operating instructions
provided with each component.
Amplifier or MD deck
To the digital input jack of
the digital component
To the component video input
jack of the TV or projector
A DIGITAL OUT (OPTICAL) jack
Use a digital optical cord (square, not supplied)
to connect an amplifier, MD deck or DAT deck
with a digital optical input jack. Sound is then
output when the system function is set to DVD.
By connecting this system to the optical input
jack of the optional amplifier equipped with
Dolby Digital or DTS decoder, you can enjoy
the 5.1 channel sound.
In addition, when the CD or DVD audio is linear
PCM, you can make a digital recording from this
system to an MD deck or DAT deck.
TV or projector
MD deck or VCR, etc.
From the audio output jack
of the connected component
Notes
• When playing a VIDEO CD or MP3 audio tracks,
you cannot output digital audio.
• You can record digital audio from this system only
when DVD function is selected.
• You cannot make a digital recording of a copy
guarded disc using a digital component connected to
this system. Also, playback may not be possible
depending on the connected component.
• DVD linear PCM output is output at a sampling
frequency of 48 kHz regardless of the disc being
played back.
• When you connect a component that does not support
Dolby Digital or DTS to the DIGITAL OUT
(OPTICAL) jack and output a Dolby Digital or DTS
bit stream, noise may be heard from the connected
component.
To the S video input jack
of the TV
TV
continued
GB
37
Advertisement
Table of Contents
