Sony TC-TX313 Operating Instructions Manual page 7

Other operations
To
Press
Stop playing π (or TAPEp*).
∏ (or TAPEP*).
Pause
Press again to resume playing.
Fast-forward π, then ‚ (or TAPE)*) for
the top side.
π, then º (or TAPE0*) for
the bottom side.
Rewind π, then º (or TAPE0*) for
the top side.
π, then ‚ (or TAPE)*) for
the bottom side.
‚ (or TAPE)*) for the top
Find the
succeeding side.
º (or TAPE0*) for the
track (AMS**)
bottom side.
Find the º (or TAPE0*) for the top
preceding track side.
(AMS**) ‚ (or TAPE)*) for the
bottom side.
Remove the § on the tape deck.
cassette
Adjust the
VOLUME +/– on the remote
volume
(or turn VOLUME on the DHC-
MD313).
* Use the remote supplied with the DHC-MD313.
**The Automatic Music Sensor (AMS) feature
detects a blank space of more than four seconds
between tracks to locate tracks quickly.
Tips
• When you press POWER on the tape deck, only
the tape deck turns on. Press POWER on the
DHC-MD313 to turn on the DHC-MD313
component system.
• The cassette indicator lights up in red when a
cassette is inserted and goes off when no cassette
is inserted.
• Pressing · or ª when the tape deck is off
automatically turns on the tape deck and starts
playing a tape if there is a cassette inserted (One
Touch Play).
• Inserting the tape when the power is off
automatically turns on the tape deck only. Press
POWER on the DHC-MD313 to turn on the DHC-
MD313 component system.
• You can switch from another source to the tape
deck just by pressing · or ª (Automatic
Source Selection).
• To start playing automatically from the beginning
of the tape after fast winding (Auto Play), press
· while holding down º (for the top side) or
press ª while holding down ‚ (for the bottom
side).
• When you want to reduce the hiss noise in low-
level high-frequency signals, set DOLBY NR to
ON.
• Using the timer function on the DHC-MD313, you
can wake up to music at a preset time. For details,
refer to "Wake up to music" in the DHC-MD313
component system Instruction Manual. When you
set the Wake-up timer, DOLBY NR must be set on
the tape deck.
Note
The AMS feature may not work in the following
cases:
— the blank space between tracks is four seconds
or less.
— the sound source recorded on the right
channel is different from that on the left
channel as with a KARAOKE tape.
— low volume or low sound continues for a long
time.
— the TV is too close to the tape deck.
7